Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for SIA Made Power Seat)

FRONT SEAT ASSEMBLY (for SIA Made Power Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read Precaution thoroughly before servicing.
    for Separate Type Yaw Rate Sensor: (Click here)
    for Built-in Type Yaw Rate Sensor: (Click here)
  2. If the side airbag has deployed, replace the front seat airbag assembly, front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


3. REMOVE REAR OUTER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.



    B280204
  1. Disengage the 2 claws to remove the rear outer seat track bracket cover.



4. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    B280203
  1. Disengage the 2 claws to remove the rear inner seat track bracket cover.



5. REMOVE FRONT SEAT ASSEMBLY


    B286593
  1. Remove the 2 bolts on the rear side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the center position. Then, operate the reclining power seat switch knob and move the seatback to the upright position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect each connector and clamp under the seat.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.