Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM (for 2GR-FE)

FRONT LOWER SUSPENSION ARM (for 2GR-FE) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed is for the LH side.



1. REMOVE FRONT FRAME ASSEMBLY
(Click here)


2. REMOVE ENGINE MOUNTING INSULATOR


    A255448
  1. Remove the 2 hole plugs from the front frame assembly.

  1. Remove the 3 nuts and engine mounting insulator LH.

    HINT:
    Perform this procedure only when replacement of the engine mounting insulator LH is necessary.



3. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY


    C167143
  1. Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.

  1. Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.