FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
Disconnect the front door opening trim weatherstrip.
| 5. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 6 claws and remove the rear door scuff plate LH.
| 6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
Disconnect the rear door opening trim weatherstrip.
| 7. REMOVE LAP BELT OUTER ANCHOR COVER |
![]() |
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.
| 9. REMOVE CENTER PILLAR LOWER GARNISH |
![]() |
Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.
| 10. REMOVE CENTER PILLAR UPPER GARNISH |
![]() |
Remove the 2 screws.
Disengage the clip.
Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.
| 11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
![]() |
Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
| *1 | Protective Tape |
![]() |
Remove the 2 bolts and front seat outer belt assembly.
| 12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Remove the 2 bolts.
Disengage the guide and remove the front shoulder belt anchor adjuster assembly.