AUTOMATIC TRANSAXLE ASSEMBLY > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
| 2. REMOVE FRONT FRAME ASSEMBLY |
![]() |
Disconnect the oil pressure switch connector and 2 clamps.
![]() |
Disconnect the 2 clamps and vacuum switching valve connector.
Remove the bolt and disconnect the front engine mounting insulator.
![]() |
Remove the nut and disconnect the engine mounting insulator LH.
![]() |
Remove the nut and disconnect the engine mounting insulator RH.
Remove the front frame assembly.
| 3. REMOVE TCM |
![]() |
Turn the lock lever and disconnect the connector from the TCM.
![]() |
Remove the 2 bolts and TCM from the automatic transaxle assembly.
| 4. REMOVE TRANSMISSION OIL COOLER |
![]() |
Disconnect the breather plug and remove the clamp.
Remove the No. 4 water by-pass hose.
![]() |
Remove the No. 1 oil cooler outlet hose and No. 1 oil cooler inlet hose.
| *1 | No. 1 Oil Cooler Outlet Hose |
| *2 | No. 1 Oil Cooler Inlet Hose |
![]() |
Remove the 2 bolts and transmission oil cooler with the transmission oil cooler stay from the automatic transaxle assembly.
| 5. SEPARATE WIRE HARNESS |
![]() |
Remove the bolt and disconnect the connector and 7 clamps from the automatic transaxle assembly.
| 6. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY |
Using the transmission jack attachment, set the automatic transaxle assembly on a transmission jack.
![]() |
Remove the 11 bolts and transaxle.
| 7. REMOVE FRONT ENGINE MOUNTING BRACKET |
![]() |
Remove the 3 bolts and front engine mounting bracket.
| 8. REMOVE WIRE HARNESS CLAMP BRACKET |
![]() |
Remove the 5 bolts and 5 clamp brackets.
| 9. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.
| 10. REMOVE SPEEDOMETER DRIVEN HOLE (ATM) COVER SUB-ASSEMBLY |
![]() |
Remove the bolt and speedometer driven hole (ATM) cover sub-assembly from the automatic transaxle assembly.
Remove the O-ring from the speedometer driven hole (ATM) cover sub-assembly.
| 11. REMOVE TORQUE CONVERTER ASSEMBLY |
![]() |
Remove the torque converter assembly from the automatic transaxle assembly.
| 12. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Press on the splines of the stator with a finger and rotate the stator. Check that the stator rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.
If necessary, clean the torque converter and recheck the one-way clutch.
Replace the torque converter if the one-way clutch still fails the inspection.
![]() | Difficult |
![]() | Smooth |
![]() |
Inspect the torque converter assembly.
If any of the following problems are present, replace the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
Replace the ATF in the torque converter.
![]() |
Clean and check the oil cooler and oil pipe line.
![]() |
Prevent deformation of the torque converter and damage to the oil pump gear.
| *a | CORRECT |
| *b | INCORRECT |
| *c | Bottom is damaged |