Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE TORQUE CONVERTER ASSEMBLY


    C157087
  1. Remove the torque converter assembly from the automatic transaxle assembly.



3. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C134962
  1. Remove the 18 bolts and oil pan from the transaxle.

    NOTICE:
    Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan sub-assembly.

  1. Remove the gasket from the oil pan.



    C134963E03
  1. Remove the 2 magnets from the oil pan.
    Text in Illustration 
    *1
    Magnet



    AT00103
  1. Examine particles in the oil pan.

    1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the oil pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      Bearing, gear and plate wear
      Brass (non-magnetic):
      Bushing wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C136687
  1. Remove the 2 bolts and oil strainer from the valve body.



    C136688E03
  1. Remove the O-ring from the oil strainer.
    Text in Illustration 
    *1
    O-ring



5. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C136689
  1. Remove the 11 bolts and valve body from the transaxle.

    NOTICE:
    When removing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and the transaxle case to interfere with each other.



6. REMOVE MANUAL VALVE


    C190507
  1. Remove the manual valve from the valve body.