Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 COOLER THERMISTOR


    E151029E04
  1. Install the No. 1 cooler thermistor as shown in the illustration.
    Part
    Length
    A
    34.3 mm
    1.35 in.
    B
    20.9 mm
    0.82 in.
    C
    50 mm
    1.96 in.
    Text in Illustration 
    *a
    Fixed Part
    *b
    Sensor Part

    NOTICE:
    1. Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the thermistor, do not apply excessive force to the wire.
    4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

  1. Engage the 2 clamps.



2. INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY
(Click here)