WATER PUMP > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR COOLANT LEAK |
Visually inspect the engine compartment for the following conditions:
There is a large amount of coolant in the engine compartment or on the underside of the hood near the V-ribbed belt.
Liquid coolant is dripping from around the engine water pump assembly.
The coolant level in the reserve tank assembly is below the low line and there are traces of leakage around the engine water pump assembly.
If any of the above conditions exist, replace the engine water pump assembly.
If none of the above conditions exist, perform the following inspection (inspection of the area around the engine water pump assembly).
Remove the V-ribbed belt (Click here).
Separate the water pump pulley .
Inspect the area around the engine water pump assembly.
![]() |
Press a piece of paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.
| *1 | Drain Plug |
Install the water pump pulley .
| 2. INSPECT ENGINE WATER PUMP ASSEMBLY |
![]() |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the engine water pump assembly.
Install the V-ribbed belt (Click here).