RADIATOR > INSTALLATION |
| 1. INSTALL RADIATOR ASSEMBLY |
![]() |
Install the fan assembly to the radiator with the 2 guides at the bottom and 3 claws on the top.
| *1 | Guide |
Install the 2 lower radiator supports to the radiator assembly.
![]() |
Install the radiator with fan assembly.
Install the condenser assembly with the 4 bolts.
Connect the 2 connectors and the 2 clamps.
| 2. INSTALL UPPER RADIATOR SUPPORT |
Install the 2 radiator support cushions to the radiator assembly.
Install the upper radiator support with the 5 bolts and connect the hood lock control cable clamp to the upper radiator support.
Connect the 2 connectors.
| 3. INSTALL HOOD LOCK ASSEMBLY |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 3 bolts.
w/ Engine Hood Courtesy Switch:
Connect the connector.
| 4. CONNECT NO. 2 RADIATOR HOSE |
Connect the No. 2 radiator hose and clamp.
| 5. CONNECT NO. 1 RADIATOR HOSE |
Connect the No. 1 radiator hose.
| 6. INSTALL RADIATOR RESERVE TANK ASSEMBLY |
Install the radiator reserve tank with the 2 bolts.
Connect the radiator reserve tank hose.
| 7. INSTALL RADIATOR GRILLE SUB-ASSEMBLY |
Engage the 8 claws to install the radiator grille sub-assembly.

| *A | for Standard | *B | for Sport Package |
Install the 3 clips.
| 8. INSTALL INLET AIR CLEANER ASSEMBLY |
Install the inlet air cleaner with the 2 bolts.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Slowly pour coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level is low, add coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand to bleed air.
Stop the engine and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 11. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
| 12. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 7 clips.
| 13. INSTALL ENGINE UNDER COVER LH |
| 14. INSTALL ENGINE UNDER COVER RH |
| 15. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH |
| 16. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH |