Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL BLIND SPOT MONITOR COVER
  1. Engage the claw.

  1. Install the blind spot monitor cover with the 2 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL BLIND SPOT MONITOR SENSOR


    E226441E01
  1. Connect the connector.
    Text in Illustration 
    *A
    for RH Side:
    *B
    for LH Side:
    *1
    Identification Mark

    NOTICE:
    1. Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.
    2. Confirm the identification marks on the blind spot monitor sensor before installing it.
    3. If the blind spot monitor sensors are not installed to the correct side, the blind spot monitor system will not operate.

  1. Install the blind spot monitor sensor with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. for LH Side:

    1. Engage the 2 clamps.

  1. for RH Side:

    1. Engage the clamp.



3. INSTALL REAR BUMPER ASSEMBLY
(Click here)


4. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION
  1. Refer to operation check (Click here).

    SST
    09870-60000   (09870-60010)
    09870-60040  



5. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)