BLIND SPOT MONITOR SYSTEM > OPERATION CHECK |
| Blind spot monitor beam axis inspection |
When performing the blind spot monitor beam axis inspection, move the vehicle to a place where the space shown in the illustration can be secured.

Procedure to enter the Test Mode
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the blind spot monitor main switch (warning canceling switch assembly) on.
Turn the Techstream on.
Switch the blind spot monitor sensor to Test Mode using the Techstream. Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / Test Mode.
![]() |
Perform the blind spot monitor beam axis inspection.
Check that the outer rear view mirror indicators are not illuminated.
Place the reflector at position A.
Enter Test Mode using the Techstream. Move the reflector from position A to B as shown in the illustration.

After placing the reflector in the specified position, quickly exit the inspection area and make sure that objects other than the reflector are not in the inspection area and check that the blind spot monitor indicator does not illuminate.
Move the reflector from position B to C as shown in the illustration.
After placing the reflector in the specified position, quickly exit the inspection area and make sure that objects other than the reflector are not in the inspection area and check that the blind spot monitor indicator illuminates.
Finish Test Mode.
| The Blind Spot Monitor Installation Condition Inspection |
Remove the rear bumper (Click here).
Attach a jig similar to the one shown in the illustration to the outward facing surface of the blind spot monitor sensor and check that the blind spot monitor sensor is perpendicular to the floor surface or within the allowable range.


| A | B | |
| Blind spot monitor sensor RH | 17mm (0.66 in) | -17mm (-0.66 in) |
| Blind spot monitor sensor LH | 8mm (0.31 in) | -26mm (1.02 in) |
![]() |
Using the sensor installation stud bolt center lines as a reference, check that the stud bolts are as shown in the illustration.
| Dimension | Specified Value |
| y | 26 to 66mm (1.03 to 2.59 in) |