Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE BLIND SPOT MONITOR SENSOR


  1. for LH Side:



      E226404
    1. Disengage the 2 clamps.



  1. for RH Side:



      E226408
    1. Disengage the clamp.



    E226405
  1. Remove the 3 nuts.



    E226406
  1. Disconnect the connector to remove the blind spot monitor sensor.

    NOTICE:
    Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.



3. REMOVE BLIND SPOT MONITOR COVER


    E226407
  1. Remove the 2 nuts.

  1. Disengage the claw to remove the blind spot monitor cover.