Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER

NAVIGATION RECEIVER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
  2. A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken when handling the navigation receiver assembly.
  3. When removing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


4. REMOVE BOX BOTTOM MAT


    B279879
  1. Remove the box bottom mat.



5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B279880
  1. Remove the 2 screws <C> or <D>.



    B279881
  1. Disengage the 4 clips and guide as shown in the illustration.

  1. Disconnect each connector to remove the upper console panel sub-assembly.



6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B279875
  1. Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.



    B279876
  1. Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.



    B279877
  1. Disengage the 3 claws and 2 clips as shown in the illustration.



    B279874
  1. Disengage the clamp.

  1. Disconnect the connector to remove the center instrument cluster finish panel assembly.



7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    B279890
  1. Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.



8. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    E226808E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    E223757
  1. Remove the 4 bolts.



    E226770
  1. Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.

  1. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.



9. REMOVE NO. 1 RADIO RECEIVER BRACKET


    E223738
  1. Remove the 5 screws and No. 1 radio receiver bracket.



10. REMOVE NO. 2 RADIO RECEIVER BRACKET


    E230755
  1. Remove the 5 screws and No. 2 radio receiver bracket.



11. REMOVE HARD DISK DRIVE


    E223753
  1. Remove the 2 screws.

  1. Disengage the 2 guides to remove the cover.



    E223754
  1. Pull out the hard disk drive from the navigation receiver assembly or radio and display receiver assembly in the direction shown by the arrow in the illustration to remove it.



12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    E227523
  1. Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.



13. REMOVE NAVIGATION COMPUTER SUB-ASSEMBLY