Home › Power Source / Network ยท NETWORKING › NETWORK GATEWAY ECU

NETWORK GATEWAY ECU > REMOVAL

for Preparation Click here


NOTICE:
  1. When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
  2. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here).



2. REMOVE ECU INTEGRATION BOX RH
(Click here).


3. REMOVE NETWORK GATEWAY ECU


    C239503
  1. Disengage the 2 claws and remove the network gateway ECU.