IGNITION SWITCH > REMOVAL |
| 1. REMOVE STEERING COLUMN ASSEMBLY |
| 2. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY |
Using a center punch, mark the center of the 2 tapered-head bolts.
Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.
![]() |
Using a screw extractor, remove each tapered-head bolt, and then remove the steering column upper with switch bracket assembly from the steering column assembly.
| 3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY |
![]() |
Disengage the 2 claws and remove the ignition or starter switch assembly.