CANISTER > REMOVAL |
| 1. REMOVE FUEL TANK ASSEMBLY |
| 2. REMOVE CHARCOAL CANISTER ASSEMBLY |
![]() |
Disconnect the purge line hose.
Disconnect the connector from the charcoal canister leak detection pump sub-assembly.
Disconnect the air line tube.
| *1 | Tube Connector |
| *2 | O-ring |
| *3 | Pipe (charcoal canister leak detection pump sub-assembly) |
| *a | Pinch |
| *b | Push |
Push the air line tube firmly toward the charcoal canister side.
Pinch the air line tube as shown in the illustration.
Pull out the air line tube.
![]() |
Remove the 3 bolts and guide.
Separate the clip from the body to remove the charcoal canister assembly.
| 3. REMOVE CHARCOAL CANISTER BASE BRACKET |
![]() |
Disengage the claw and remove the charcoal canister base bracket.
| 4. REMOVE CHARCOAL CANISTER SUPPORT BRACKET |
![]() |
Disengage the claw and remove the charcoal canister support bracket.
| 5. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY |
Before removing the charcoal canister leak detection pump sub-assembly, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.
![]() |
While disengaging the 2 claws as shown in the illustration, push the charcoal canister leak detection pump sub-assembly upwards using a screwdriver to remove it.
Check if the canister contains foreign matter such as mud or water.
![]() |
Visually check that the inside of the canister is free of foreign matter.
Hold the canister upside down to make sure that the canister is free of foreign matter.
If the canister contains foreign matter, replace the canister.