Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B15FE    XM Tuner Antenna Disconnected

DTC    B15FF    XM Tuner Antenna Short

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the roof antenna assembly which is connected to the navigation ECU sub-assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15FE
The roof antenna assembly is not connected.
  1. Antenna cord sub-assembly
  2. No. 2 antenna cord sub-assembly
  3. Harness or connector
  4. Roof antenna assembly
  5. Navigation ECU sub-assembly
B15FF
A short occurs in the roof antenna assembly.

INSPECTION PROCEDURE

NOTICE:
After replacing the navigation ECU sub-assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.REPLACE ANTENNA CORD SUB-ASSEMBLY
  1. Replace the antenna cord sub-assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

END 

2.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the No. 2 antenna cord sub-assembly.

  1. Measure the resistance of the No. 2 antenna cord sub-assembly to check for an open circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the No. 2 antenna cord sub-assembly and body ground to check for a short circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY (Click here)
OK


3.REPLACE HARNESS OR CONNECTOR
  1. Replace the harness or connector.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 4
OK

END 

4.REPLACE ROOF ANTENNA ASSEMBLY
  1. Replace the roof antenna assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK

END