2 or more ECUs and/or sensors do not appear on the Techstream "CAN Bus Check" screen.
| One side of CAN branch line is open, or output signals are incomplete.
- Network gateway ECU*1
- ECM
- Main body ECU (Multiplex network body ECU)
- Combination meter assembly
- Brake actuator assembly (Skid control ECU)
- Steering sensor
- Clearance warning ECU assembly*2
- Air conditioning amplifier assembly
- Smart key ECU assembly (Certification ECU)*3
- Navigation ECU sub-assembly*4*5
- Radio and display receiver assembly*6
- Power steering ECU with motor assembly*7
- Power steering ECU assembly*8*9
- Airbag sensor assembly
- Yaw rate sensor*10
|