Result List of How to Proceed with Troubleshooting
Symptom
| Suspected Area
| See page
|
The result of "How to Proceed with Troubleshooting" is "Open in CAN Main Bus Line".
| Open in CAN Main Bus Line (Includes DLC3 branch lines and terminating resistors)
|
Click here
|
The result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines".
| Short in CAN Bus Lines
|
Click here
|
The result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line".
| Short to +B in CAN Bus Line
|
Click here
|
The result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line".
| Short to GND in CAN Bus Line
|
Click here
|
The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line".
| Open in One Side of CAN Branch Line
|
Click here
|
Communication Stop Mode Table
Symptom
| Suspected Area
| See page
|
"Skid Control (ABS/VSC/TRAC)" is not displayed on the Techstream.
| Skid Control ECU Communication Stop Mode
|
Click here
|
"Power Steering (EPS)" is not displayed on the Techstream.
| Power Steering ECU Communication Stop Mode
|
Click here
|
"Spiral cable (Steering Angle Sensor)" is not displayed on the Techstream.
| Steering Angle Sensor Communication Stop Mode
|
Click here
|
"CAN Gateway1" is not displayed on the Techstream.
| Gateway ECU Communication Stop Mode
|
Click here
|
"ECM (Engine)" is not displayed on the Techstream.
| ECM Communication Stop Mode
|
Click here
|
"Air Conditioning Amplifier" is not displayed on the Techstream.
| Air Conditioner Amplifier Communication Stop Mode
|
Click here
|
"Main Body" is not displayed on the Techstream.
| Main Body ECU Communication Stop Mode
|
Click here
|
"Clearance Warning (Intuitive Parking Assist2)" are not displayed on the Techstream.
| Clearance Warning ECU Communication Stop Mode
|
Click here
|
"Combination Meter" is not displayed on the Techstream.
| Combination Meter ECU Communication Stop Mode
|
Click here
|
"Certification (Smart)" is not displayed on the Techstream.
| Certification ECU Communication Stop Mode
|
Click here
|
"Airbag" is not displayed on the Techstream.
| Center Airbag Sensor Communication Stop Mode
|
Click here
|
"Display and Navigation (AVN1)" is not displayed on the Techstream.
| Navigation ECU Communication Stop Mode
|
Click here
|
"Display and Navigation (AVN1)" is not displayed on the Techstream.
| Audio Receiver Assembly Communication Stop Mode
|
Click here
|
"Yaw Rate Sensor" is not displayed on the Techstream.
| Yaw Rate Sensor Communication Stop Mode
|
Click here
|
The suspected communication stop area can be determined based on the ECU or sensor that was not displayed in CAN Bus Check and by referring to the table below.