Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM


E226161E16


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
  1. Disconnect the radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I155-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    I155-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position other than R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the radio and display receiver assembly connector.

  1. Disconnect the park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I155-2 (REV) - E4-2 (RL)
    Always
    Below 1 Ω
    I155-2 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)
  1. Disconnect the park/neutral position switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-1 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Proceed to the next step based on the check result.

    Result:
    Result
    Proceed to
    NG
    A
    OK (for U660E)
    B
    OK (for U760E)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U660E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U760E) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR