DTC P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0128 | All of the following conditions are met for 5 seconds (2 trip detection logic): (a) Cold start (b) The engine is warmed up (c) The engine coolant temperature is less than 75°C (167°F) |
|

| Related DTCs | P0128: Coolant thermostat |
| Required Sensors / Components (Main) | Thermostat Engine coolant temperature sensor |
| Required Sensors / Components (Related) | Intake air temperature sensor Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | 750 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | P0010, P0020 (Camshaft timing oil control valve bank 1, 2) P0011, P0021 (VVT system bank 1, 2 - advance) P0012, P0022 (VVT system bank 1, 2 - retard) P0013, P0023 (Exhaust camshaft timing oil control valve bank 1, 2) P0014, P0024 (Exhaust VVT system bank 1, 2 - advance) P0015, P0025 (Exhaust VVT system bank 1, 2 - retard) P0016, P0018 (VVT system bank 1, 2 - misalignment) P0017, P0019 (Exhaust VVT system bank 1, 2 - misalignment) P0031, P0032, P0051, P0052, P101D, P103D (Air fuel ratio sensor heater) P0102, P0103 (Mass air flow meter) P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) P014C, P014D, P014E, P014F, P015A, P015B, P015C, P015D, P2195, P2196, P2197, P2198, P2237, P2238, P2239, P2240, P2241, P2242, P2252, P2253, P2255, P2256 (Air fuel ratio sensor) P0171, P0172, P0174, P0175 (Fuel system) P0301, P0302, P0303, P0304, P0305, P0306 (Misfire) P0335 (Crankshaft position sensor) P0340, P0342, P0343, P0345, P0347, P0348 (VVT sensor) P0351, P0352, P0353, P0354, P0355, P0356 (Igniter) P0365, P0367, P0368, P0390, P0392, P0393 (Exhaust VVT sensor) P0500 (Vehicle speed sensor) P219A, P219B (Air-fuel ratio imbalance) |
| Battery voltage | 11 V or higher |
| Either of the following conditions is met | 1 or 2 |
| 1. All of the following conditions are met | - |
| Engine coolant temperature at engine start - Intake air temperature at engine start | -15 to 7°C (-27 to 12.6°F) |
| Engine coolant temperature at engine start | -10 to 56°C (14 to 133°F) |
| Intake air temperature at engine start | -10 to 56°C (14 to 133°F) |
| 2. All of the following conditions are met | - |
| Engine coolant temperature at engine start - Intake air temperature at engine start | Higher than 7°C (12.6°F) |
| Engine coolant temperature at engine start | 56°C (133°F) or less |
| Intake air temperature at engine start | -10°C (14°F) or higher |
| Accumulated time that vehicle speed is 128 km/h (80 mph) or more | Less than 20 seconds |
| Duration that all of the following conditions are met | 5 seconds or more |
| Estimated engine coolant temperature | 75°C (167°F) or higher |
| Engine coolant temperature sensor output | Less than 75°C (167°F) |

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0128) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0128 is output | A |
| DTC P0128 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
|
| ||||
| OK | |
| 3.INSPECT THERMOSTAT |
Inspect the thermostat (thermostat opening temperature) (Click here).
|
| ||||
| OK | ||
| ||