TIRE PRESSURE WARNING RECEIVER > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER |
Connect the connector to the tire pressure warning ECU and receiver.
Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.
Install the bolt to install the tire pressure warning ECU and receiver.
| 2. INSTALL ROOF SIDE INNER GARNISH RH |
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.
| *1 | Alignment Mark (Blue) |
| 4. INSTALL REAR SIDE SEATBACK ASSEMBLY RH |
Engage the hook.
Install the rear side seatback assembly RH with the 2 bolts.
Connect the connector.
Connect the rear seat outer belt to the rear seat shoulder belt guide.
| 5. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 6. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
![]() |
Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.
Confirm that the seat cushion is firmly installed.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. REGISTER TRANSMITTER ID |
| 9. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 10. PERFORM INITIALIZATION |
| 11. INSPECT SRS WARNING LIGHT |