Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2311    Power Window Motor Malfunction

for Preparation Click here


DESCRIPTION

The power window regulator motor assembly LH (for driver door) is operated by the power window regulator master switch assembly. The power window regulator motor assembly LH (for driver door) has motor, regulator and ECU functions.
This DTC is stored when the power window regulator motor assembly LH (for driver door) has a malfunction, or the ECU built into the regulator motor assembly determines that the fully closed window position has deviated approximately 20 mm (0.787 in.) or more from the normal position.

D-Door Motor (Power Window Regulator Motor Assembly LH (for Driver Door)) 
DTC No.
DTC Detection Condition
Trouble Area
B2311
  1. Either condition is met:
    1. Power window regulator motor assembly malfunctions
    2. When ECU in power window regulator motor assembly determines that fully closed window position has deviated approx. 20 mm (0.787 in.) or more from normal position
  1. Power window regulator motor assembly LH (for driver door)
  2. Incorrect installation of power window components
  3. Overheated power window regulator motor assembly

INSPECTION PROCEDURE

NOTICE:
  1. DTC B2311 can be stored in the power window regulator motor assembly LH (for driver door).
  2. If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (Click here).
  3. If a power window regulator motor assembly LH (for driver door) and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (Click here).

1.PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER DOOR WINDOW MOTOR)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / D-Door Motor / Active Test.

  1. Perform the Active Test according to the display on the Techstream.

    CAUTION:
    Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.


    D-Door Motor (Power Window Regulator Motor Assembly LH (for Driver Door)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power Window
    Power window
    OFF / UP / DOWN
    -

    OK:
    Driver door power window motor operates.



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR) (Click here)
OK


2.PERFORM INITIALIZATION (DRIVER DOOR WINDOW)
  1. Initialize the power window regulator motor assembly LH (for driver door) (Click here).


NEXT


3.CHECK POWER WINDOW CONTROL SYSTEM (DRIVER DOOR WINDOW)
  1. Check that the driver door power window operates normally by opening and closing the window (Click here).

    OK:
    Driver door power window operates normally.



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR) (Click here)
OK


4.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY
  1. Check that the power window components are installed correctly.

    OK:
    Power window components are installed correctly.



NG
INSTALL PARTS CORRECTLY
OK


5.CHECK DTC OUTPUT
  1. Turn the ignition switch off.

  1. Wait for at least 10 seconds, and then turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    OK:
    B2311 output does not recur.



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR) (Click here)
OK

END