Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Engine Switch Illumination Circuit

for Preparation Click here


DESCRIPTION

The illuminated entry system controls the engine switch illumination.

WIRING DIAGRAM


E212454E01


INSPECTION PROCEDURE

NOTICE:
  1. Before performing the following inspection, check that the engine switch illumination has not been turned off using the rheostat function.
  2. The engine switch illumination can be turned off by using the rheostat knob to select the minimum illuminance level with the taillights on.

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check that the illumination operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Engine switch illumination
    ON/OFF
    -

    OK:
    Engine switch illumination comes on.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT ENGINE SWITCH
  1. Remove the engine switch (Click here for 2AR-FE, Click here for 2GR-FE).

  1. Inspect the engine switch (Click here for 2AR-FE, Click here for 2GR-FE).

OK:
Engine switch illumination comes on.


Result 
Result
Proceed to
OK
A
NG (for 2AR-FE)
B
NG (for 2GR-FE)
C


B
REPLACE ENGINE SWITCH (Click here)

C
REPLACE ENGINE SWITCH (Click here)
A


3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
  1. Disconnect the I78 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the I58 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-9 (SWIL) - I78-16 (SWIL)
    Always
    Below 1 Ω
    I58-6 (AGND) - I78-24 (AGND)
    Always
    Below 1 Ω
    I58-9 (SWIL) - Body ground
    Always
    10 kΩ or higher
    I58-6 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)