AUDIO AND VISUAL SYSTEM (for Radio and Display Type with Intuitive Parking Assist System) > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - BATTERY, BODY GROUND) |
Disconnect the navigation ECU sub-assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I64-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I64-4 (+B1) - I64-7 (GND1) | Always | 11 to 14 V |
| I64-3 (ACC1) - I64-7 (GND1) | Ignition switch ACC | 11 to 14 V |
| I67-1 (IG) - I64-7 (GND1) | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||