AIR FUEL RATIO SENSOR > REMOVAL |
| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 2. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.
| 3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Disconnect the air fuel ratio sensor connector.
![]() |
Separate the wire harness clamp.
![]() |
Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.
| 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Disconnect the air fuel ratio sensor connector.
Disconnect the harness clamp.
![]() |
Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.