DTC B2785 Communication Malfunction between ECUs Connected by LIN |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2785 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
Disconnect the I24 steering lock ECU (steering lock actuator assembly) connector.
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-17 (LIN) - I24-5 (LIN) | Always | Below 1 Ω |
| I78-17 (LIN) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| I78-17 (LIN) - Body ground | Always | Below 1 V |
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)) |
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| DTC B2785 is output | A |
| DTC B2785 is not output | B |
|
| ||||
| A | ||
| ||