STEERING WHEEL (for 3 Spoke) > INSTALLATION |
| 1. INSTALL STEERING SHAKE DAMPER |
Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
| 2. INSTALL CRUISE CONTROL SWITCH WIRE |
Install the cruise control switch wire.
| 3. INSTALL CRUISE CONTROL MAIN SWITCH |
Connect the connector.
![]() |
Install the cruise control switch with the 2 screws shown in the illustration.
| 4. CONNECT NO. 1 SWITCH WIRE (for 2AR-FE) |
Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).
![]() |
Install new 2 clamps as shown in the illustration.
| *1 | Clamp |
| *a | 0 to 40° |
| *b | 1 to 3 mm |
Engage the 5 guides to install the No. 1 switch wire.
| 5. CONNECT NO. 1 SWITCH WIRE (for 2GR-FE) |
Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).
![]() |
Install new 2 clamps as shown in the illustration.
| *1 | Clamp |
| *a | 0 to 40° |
| *b | 1 to 3 mm |
Engage the 5 guides to install the No. 1 switch wire.
| 6. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for 2AR-FE) |
Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.
| 7. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for 2GR-FE) |
Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.
| 8. INSTALL STEERING PAD SWITCH ASSEMBLY |
Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.
Install the 2 screws.
Engage the clamp.
Connect the No. 1 switch wire connector.
Connect the steering pad switch connector to the spiral cable sub-assembly.
![]() |
Pass the wire harness over the 2 guides.
| 9. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 10. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Check if the spiral cable sub-assembly is centered.
![]() | Colored Part |
If the spiral cable sub-assembly is not centered, center it.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
![]() | Colored Part |
![]() | Interlock |
| 11. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
| *a | Matchmark |
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.
| 12. CHECK STEERING WHEEL CENTER POINT |
| 13. INSTALL HORN BUTTON ASSEMBLY |