Home › Steering › STEERING COLUMN › STEERING PAD SWITCH (for 3 Spoke)

STEERING PAD SWITCH (for 3 Spoke) > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Engage the clamp.

  1. Connect the No. 1 switch wire connector.

  1. Connect the steering pad switch connector to the spiral cable sub-assembly.



    C239683
  1. Pass the wire harness over the 2 guides.



2. INSTALL HORN BUTTON ASSEMBLY
(Click here)