Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR

BRAKE ACTUATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. SEPARATE SUCTION HOSE SUB-ASSEMBLY


    C239179
  1. Disengage the clamp and separate the suction hose sub-assembly from the brake actuator bracket assembly.



4. REMOVE BRAKE ACTUATOR WITH BRACKET


    C239180E01
  1. Disengage the claw (a) and raise the lock lever.

  1. Engage the claw (b) and disconnect the connector from the brake actuator assembly.

    NOTICE:
    Be careful not to allow any brake fluid to enter the connector.



    C239182E01
  1. Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
    Text in Illustration 
    *a
    From 1st Chamber of Master Cylinder Sub-assembly
    *b
    From 2nd Chamber of Master Cylinder Sub-assembly
    *c
    To Front Wheel Cylinder Assembly LH
    *d
    To Rear Wheel Cylinder Assembly RH
    *e
    To Rear Wheel Cylinder Assembly LH
    *f
    To Front Wheel Cylinder Assembly RH

  1. Use tags or make a memo to identify the places to reconnect the lines.



    C239183
  1. Remove the 3 bolts and brake actuator with bracket from the vehicle body.

    NOTICE:
    Do not damage the brake lines, suction hose sub-assembly or wire harness.



5. REMOVE BRAKE ACTUATOR ASSEMBLY


    C238434
  1. Loosen the 3 nuts and remove the brake actuator assembly from the brake actuator bracket assembly.