Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2179/79    Tire Pressure Monitor ECU Communication Stop

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line.

DTC No.
DTC Detection Condition
Trouble Area
C2179/79
Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more.
  1. Main body ECU (Multiplex network body ECU)
  2. Wire harness or connector
  3. Tire pressure warning ECU and receiver

WIRING DIAGRAM


C240095E03


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.
  3. When replacing the tire pressure warning ECU and receiver on vehicles equipped with the wireless door lock control system (w/o smart key system), be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement (Click here).

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Disconnect the tire pressure warning ECU and receiver O25 or O33 connector and main body ECU (multiplex network body ECU) I13 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O25-5 (PRG) - I13-4 (PRG)*1
    O33-5 (PRG) - I13-4 (PRG)*2
    Always
    Below 1 Ω
    O25-5 (PRG) - Body ground*1
    O33-5 (PRG) - Body ground*2
    Always
    10 kΩ or higher

    1. *1: w/ Wireless Door Lock Control System
    2. *2: w/o Wireless Door Lock Control System



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
  1. Replace the tire pressure warning ECU and receiver (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    OK:
    DTC C2179/79 is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END