GLASS BREAKAGE SENSOR ECU > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT PANEL GARNISH RH |
![]() |
Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish RH.
| 4. REMOVE FRONT DOOR SCUFF PLATE RH |
| 5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH |
| 6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Disconnect the front door opening trim weatherstrip RH.
| 7. REMOVE INSTRUMENT SIDE PANEL RH |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.
| 8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Disengage the 4 claws.
Disengage the 2 guides to remove the No. 2 instrument panel under cover sub-assembly.
| 9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Remove the 3 bolts.
![]() |
Disengage the 3 claws to remove the lower No. 2 instrument panel airbag assembly.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Disconnect the airbag connector to remove the lower No. 2 instrument panel airbag assembly.
| 10. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 screws <C> or <D>.
Open the lower instrument panel door.
![]() |
Remove the 3 screws <C> or <D>.
![]() |
Disengage the 2 clips and guide.
![]() |
Disengage the glove compartment light as shown in the illustration.
Disconnect each connector and remove the lower instrument panel sub-assembly.
| 11. REMOVE GLASS BREAKAGE SENSOR ECU |
Disconnect the connector.
![]() |
Remove the nut and glass breakage sensor ECU.