Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › REMOTE ENGINE STARTER ECU

REMOTE ENGINE STARTER ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT PANEL GARNISH RH


    B279869
  1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish RH.



4. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and LH side .



5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side .



6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B279882
  1. Disconnect the front door opening trim weatherstrip RH.



7. REMOVE INSTRUMENT SIDE PANEL RH


    B279883
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B279885
  1. Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.



8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B279888
  1. Disengage the 4 claws.

  1. Disengage the 2 guides to remove the No. 2 instrument panel under cover sub-assembly.



9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

CAUTION:
When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side facing upward.

  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B279740
  1. Remove the 3 bolts.



    B279759
  1. Disengage the 3 claws to remove the lower No. 2 instrument panel airbag assembly.

    NOTICE:
    When removing the lower No. 2 instrument panel airbag assembly, do not pull the airbag wire harness.



    B279741E01
  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Airbag Connector Lock

  1. Disconnect the airbag connector to remove the lower No. 2 instrument panel airbag assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



10. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B280314
  1. Remove the 2 screws <C> or <D>.

  1. Open the lower instrument panel door.



    B280315
  1. Remove the 3 screws <C> or <D>.



    B280312
  1. Disengage the 2 clips and guide.



    B284908
  1. Disengage the glove compartment light as shown in the illustration.

  1. Disconnect each connector and remove the lower instrument panel sub-assembly.



11. REMOVE REMOTE ENGINE STARTER ECU
  1. Disconnect the connector.



    B279922
  1. Remove the nut and remote engine starter ECU.