Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
  1. Remove the luggage compartment floor mat.



3. REMOVE SPARE WHEEL COVER ASSEMBLY
  1. Remove the spare wheel cover assembly.



4. REMOVE BAGGAGE HOLDER NET (w/ Partition Net)
  1. Remove the baggage holder net.



5. REMOVE REAR FLOOR FINISH PLATE


    B280564
  1. Remove the 5 clips.



    B280565
  1. Disengage the 4 clips and remove the rear floor finish plate.



6. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B280637E01
  1. Push the pin and remove the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *1
    Pin



7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER


    B280568E01
  1. Remove the clip <A>.
    Text in Illustration 
    *1
    Clip <A>
    *2
    Clip <B>

  1. Remove the 2 clips <B>.



    B288522
  1. Disengage the fastener and remove the luggage compartment inner trim cover LH.



8. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    E225013
  1. Disconnect each connector.

  1. Disengage the clamp.



    E225014
  1. Remove the 4 nuts and rear combination light assembly.