DTC C1439 Steering Angle Sensor Initialization Incomplete |
DTC C1445 Vehicle Driven with Steering Angle Sensor not Initialized |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1439 | After the steering angle sensor zero point calibration at a speed of 15 km/h (9 mph) or more for 1 second or more is cleared due to, for example, fluctuations in the power source, the steering angle sensor zero point calibration cannot be obtained. |
|
| C1445 | Steering angle sensor zero point calibration cannot be obtained when the vehicle is driven without a record of steering angle sensor zero point calibration at a speed of 15 km/h (9 mph) or more for 115 seconds or more without the brake pedal being depressed. |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTCs are output (Click here).
Drive the vehicle at a speed of 50 km/h (31 mph) and turn the steering wheel to the right and left and check that no speed sensor or yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| DTCs C1439 and/or C1445 are output. | A |
| CAN communication system DTC is output. | B |
| Speed sensor and/or yaw rate and acceleration sensor DTC is output. | C |
| DTCs C1439 and C1445 are not output. | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 50 km/h (31 mph) or more for at least 30 seconds.
Check that the steering wheel is correctly centered while driving straight ahead.
|
| ||||
| OK | |
| 3.REPLACE STEERING ANGLE SENSOR |
Turn the ignition switch off.
Replace the steering angle sensor (Click here).
| NEXT | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 50 km/h (31 mph) or more for at least 120 seconds and turn the steering wheel to the right and left.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1439 and C1445 are not output. | A |
| Yaw rate and acceleration sensor DTC is output. | B |
|
| ||||
| A | ||
| ||