CLEARANCE WARNING ECU > INSTALLATION |
| 1. INSTALL CLEARANCE WARNING ECU ASSEMBLY |
Engage the 2 claws to install the clearance warning ECU assembly.
| 2. INSTALL ECU INTEGRATION BOX RH |
Install the ECU integration box RH with the 2 nuts and bolt.
Connect each connector.
| 3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
Connect each connector.
![]() |
Engage the glove compartment light as shown in the illustration.
![]() |
Engage the guide and 2 clips.
Install the lower instrument panel sub-assembly with the 5 screws <C> or <D>.
| 4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Push in the lock to install the airbag connector.
Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.
Install the 3 bolts.
| 5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.
| 6. INSTALL FRONT PANEL GARNISH RH |
Engage the 3 claws, 2 clips and 8 guides to install the front panel garnish RH.
| 7. INSTALL INSTRUMENT SIDE PANEL RH |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel RH as shown in the illustration.
| 8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Align the alignment mark (White) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.
| *1 | Alignment Mark (White) |
| 9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH |
| 10. INSTALL FRONT DOOR SCUFF PLATE RH |
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT SRS WARNING LIGHT |