Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1625    Open or Short in Steering Angle Sensor +B

for Preparation Click here


DESCRIPTION

This DTC is stored if the navigation ECU sub-assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC No.
DTC Detection Condition
Trouble Area
C1625
Open or short in steering angle sensor +B
  1. Harness or connector
  2. Steering sensor

WIRING DIAGRAM


E224380E01


INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SUPPLY)


    E224381E01
  1. Disconnect the I29 connector from the steering sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I29-1 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I29-4 (IG) - I29-1 (ESS)
    Engine switch on (IG)
    11 to 14 V
    I29-5 (BAT) - I29-1 (ESS)
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING SENSOR (Click here)