NOISE FILTER > INSTALLATION |
| 1. INSTALL RADIO SETTING CONDENSER (for Window Defogger) |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.
Engage the 2 clamps to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
| 2. INSTALL ROOF SIDE INNER GARNISH LH (for Window Defogger) |
Engage the guide.
Engage the 5 clips to install the roof side inner garnish LH.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Window Defogger) |
![]() |
Align the alignment mark (Pink) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *1 | Alignment Mark (Pink) |
| 4. INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light) |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.
![]() |
Engage the claw to insert the cover as shown in the illustration.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
| 5. INSTALL REAR SIDE SEATBACK ASSEMBLY LH |
Engage the hook.
Install the rear side seatback assembly LH with the 2 bolts.
Connect the connector.
Connect the rear seat outer belt to the rear seat shoulder belt guide.
| 6. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 7. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
![]() |
Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.
Confirm that the seat cushion is firmly installed.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT SRS WARNING LIGHT |