Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B1585    USB Media Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.
DTC Detection Condition
Trouble Area
B1585
USB Device Malfunction
  1. Non mass-storage class or incompatible protocol USB device
  2. USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)
  3. "iPod" malfunction
  4. "iPod" with unsupported firmware
  5. Unsupported "iPod" model
  1. USB device or "iPod"
  2. Navigation ECU sub-assembly

INSPECTION PROCEDURE

NOTICE:
After replacing the navigation ECU sub-assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

    HINT:
    1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
    2. Refer to System Description for compatible formats and versions (Click here).


NEXT


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the navigation ECU sub-assembly.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE