Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Power Windows do not Operate Using All Window Switch

for Preparation Click here


DESCRIPTION

The power windows operate by using the power window regulator master switch assembly or power window regulator switch assemblies.
The power window regulator master switch assembly and each power window regulator switch assembly connect the same power supply and ground lines.

WIRING DIAGRAM


B281017E06


B274527E07


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH ASSEMBLY - BATTERY AND BODY GROUND)
  1. Disconnect the power window regulator master switch assembly connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    K11-6 (B) - Body ground
    Ignition switch ON
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K11-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
  1. Replace the power window regulator master switch assembly (Click here).


NEXT


3.CHECK POWER WINDOW CONTROL SYSTEM
  1. Check the power windows operation by using the power window regulator master switch assembly and power window regulator switch assemblies.

    OK:
    All power windows operate normally.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE)