POWER SEAT SWITCH > INSTALLATION |
| 1. INSTALL FRONT POWER SEAT SWITCH (for TMMK Made) |
Install the front power seat switch to a new front seat cushion shield with the 3 screws.
| 2. INSTALL FRONT SEAT CUSHION SHIELD (for TMMK Made) |
for Driver Side:
Engage the 4 claws to install the front lumbar power seat switch to the front seat cushion shield.
Connect the front power seat switch connector.
Engage the wire harness clamp.
Engage the 2 claws to install the front seat cushion shield.
Install the screw.
| 3. CONNECT SEPARATE TYPE FRONT SEATBACK COVER (for TMMK Made) |
Connect the 2 rubber bands of the separate type front seatback cover.
| 4. INSTALL RECLINING POWER SEAT SWITCH KNOB (for TMMK Made) |
Engage the 4 claws to install the reclining power seat switch knob.
| 5. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for TMMK Made) |
Engage the 4 claws to install the slide and vertical power seat switch knob.
| 6. INSTALL FRONT SEAT ASSEMBLY (for TMMK Made) |
| 7. INSTALL FRONT POWER SEAT SWITCH (for SIA Made) |
Install the front power seat switch to the front seat cushion shield with the 3 screws.
| 8. INSTALL FRONT SEAT CUSHION SHIELD (for SIA Made Driver Side) |
Connect the front lumbar power seat switch connector.
Connect the front power seat switch connector.
Engage the 2 wire harness clamps.
Install the wire harness to the wire harness cover.
Engage the 2 claws to close the wire harness cover.
Engage the 4 claws, 7 guides and clip to install the front seat cushion shield.
| 9. INSTALL FRONT SEAT CUSHION SHIELD (for SIA Made Front Passenger Side) |
Connect the front power seat switch connector.
Engage the 2 wire harness clamps.
Install the wire harness to the wire harness cover.
Engage the 3 claws to close the wire harness cover.
Engage the 4 claws, 8 guides and clip to install the front seat cushion shield.
| 10. INSTALL NO. 1 FRONT SEAT INNER CUSHION SHIELD (for SIA Made) |
![]() |
Engage the 3 claws and 3 guides to install the front No. 1 seat inner cushion shield as shown in the illustration.
![]() |
Engage the 2 claws to install the clip to the front No. 1 seat inner cushion shield as shown in the illustration.
Install the screw.
| 11. CONNECT SEPARATE TYPE FRONT SEATBACK COVER (for SIA Made) |
Connect the rubber band of the separate type front seatback cover.
| 12. INSTALL RECLINING POWER SEAT SWITCH KNOB (for SIA Made) |
Engage the 4 claws to install the reclining power seat switch knob.
| 13. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for SIA Made) |
Engage the 4 claws to install the slide and vertical power seat switch knob.
| 14. INSTALL FRONT SEAT ASSEMBLY (for SIA Made) |