FRONT SEAT ASSEMBLY (for SIA Made Power Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
Connect each connector and clamp under the seat.
Connect the cable to the negative (-) battery terminal.
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Tighten the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Tighten the 2 bolts on the rear side of the seat.
| 2. INSTALL REAR INNER SEAT TRACK BRACKET COVER |
Engage the 2 claws to install the rear inner seat track bracket cover.
| 3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER |
Engage the 2 claws to install the rear outer seat track bracket cover.
| 4. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 5. INSPECT FRONT SEAT ASSEMBLY |
Check the power seat operation (Click here).
w/ Seat Heater System:
Check the seat heater operation.
Turn the ignition switch to ON.
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 6. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
| 7. INSPECT SRS WARNING LIGHT |