CHILD RESTRAINT SEAT TETHER ANCHOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR SEAT CUSHION ASSEMBLY |
Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
![]() |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
| a | 100 mm (3.94 in.) or less |
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 4. REMOVE REAR SEAT CUSHION LOCK HOOK |
![]() |
Disengage the claw and remove the rear seat cushion lock hook.
| 5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD |
![]() |
Remove the inner luggage compartment trim pad.
| 6. REMOVE REAR SEATBACK ASSEMBLY LH |
![]() |
Disengage the 2 fasteners as shown in the illustration.
| *1 | Fastener |
![]() |
Remove the 2 bolts and rear seatback assembly LH.
| 7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH |
Disconnect the rear seat outer belt from the rear seat shoulder belt guide.
Disconnect the connector.
![]() |
Remove the 2 bolts.
Disengage the hook and remove the rear side seatback assembly LH.
| 8. REMOVE REAR SIDE SEATBACK ASSEMBLY RH |
Disconnect the rear seat outer belt from the rear seat shoulder belt guide.
Disconnect the connector.
![]() |
Remove the 2 bolts.
Disengage the hook and remove the rear side seatback assembly RH.
| 9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH |
Disconnect the rear door opening trim weatherstrip LH.
| 10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH |
Disconnect the rear door opening trim weatherstrip RH.
| 11. REMOVE ROOF SIDE INNER GARNISH LH |
![]() |
Disengage the 5 clips.
Disengage the guide and remove the roof side inner garnish LH.
| 12. REMOVE ROOF SIDE INNER GARNISH RH |
| 13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.
| 14. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.
| 15. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH |
![]() |
Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.
| 16. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.
| 17. REMOVE CENTER STOP LIGHT SET |
![]() |
Slide the center stop light set in the order and directions shown by the arrows in the illustration while pushing it towards the rear of the vehicle to disengage the 4 claws.
![]() |
Turn the center stop light set 180 degrees as shown by the arrow in the illustration.
Disconnect the connector and remove the center stop light set.
| 18. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER |
![]() |
Using a moulding remover, disengage the 2 claws and 2 guides to remove the child restraint seat tether anchor cover.
| 19. REMOVE REAR SEAT SHOULDER BELT COVER |
![]() |
Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.
| 20. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY |
![]() |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
| *1 | Protective Tape |
Disengage the 5 guides.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
| 21. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET |
![]() |
Remove the bolt and child restraint seat tether anchor bracket.