Home › Vehicle Interior › SEAT BELT › CHILD RESTRAINT SEAT ANCHOR BRACKET

CHILD RESTRAINT SEAT ANCHOR BRACKET > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR SEAT CUSHION ASSEMBLY


  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.




      B279202E01
    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
      Standard Measurement 
      a
      100 mm (3.94 in.) or less

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.



4. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD


    B279201
  1. Remove the inner luggage compartment trim pad.



6. REMOVE REAR SEATBACK ASSEMBLY LH


    B279209E01
  1. Disengage the 2 fasteners as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B279211
  1. Remove the 2 bolts and rear seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



7. REMOVE REAR SEATBACK ASSEMBLY RH


    B279206E01
  1. Disengage the 3 fasteners as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B279208
  1. Remove the 2 bolts and rear seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285010
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly LH.



9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285009
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly RH.



10. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    B279428
  1. Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.



11. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH


    B279427
  1. Remove the 2 nuts and child restraint seat anchor bracket sub-assembly RH.