DTC U1331 Software Incompatibility with Body Control Module "B" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U1331 | Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match. |
|
| 1.CONFIRM PART NUMBER (MAIN BODY ECU) |
Check the main body ECU part number.
Check if the part number of the main body ECU installed on the vehicle is correct.
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH (Master) | B |
| DTC is output from the blind spot monitor sensor LH (Slave) | C |
|
| ||||
|
| ||||
| A | ||
| ||