Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB0    Short to +B in Outer Mirror Indicator(Master)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a +B short in the outer rear view mirror indicator RH.

DTC No.
DTC Detection Condition
Trouble Area
C1AB0
Both of the following conditions are met:
  1. Blind spot monitor main switch (warning canceling switch assembly) is on.
  1. The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time.
  1. Outer rear view mirror RH
  2. Outer rear view mirror assembly RH
  3. Wire harness or connector
  4. Blind spot monitor sensor RH

WIRING DIAGRAM


E221720E01


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.INSPECT OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)
  1. Disconnect connector O28 from the blind spot monitor sensor RH.



    C240531E27
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    O28-6 (OMIR) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor RH)



NG
Go to step 3
OK

REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)  

3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR RH)
  1. Disconnect connector IND1 from the outer rear view mirror RH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    O28-6 (OMIR) - Body ground
    Ignition switch ON
    Below 1 V



NG
Go to step 4
OK

REPLACE OUTER REAR VIEW MIRROR RH (Click here)  

4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)
  1. Disconnect connector J13 from the outer rear view mirror assembly RH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    O28-6 (OMIR) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH (Click here)