Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB2    Short to GND in Outer Mirror Indicator(Master)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a ground short in the outer rear view mirror indicator RH.

DTC No.
DTC Detection Condition
Trouble Area
C1AB2
Both of the following conditions are met:
  1. Blind spot monitor main switch (warning canceling switch assembly) is on.
  1. The current that is sent from the blind spot monitor sensor to the indicator is above a specified level for a specified period of time.
  1. Outer rear view mirror RH
  2. Outer rear view mirror assembly RH
  3. Wire harness or connector
  4. Blind spot monitor sensor RH

WIRING DIAGRAM


E221720E01


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)
  1. Disconnect connector O28 from the blind spot monitor sensor RH.

  1. Disconnect connector J13 from the outer rear view mirror assembly RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Always
    J13-6 (BSR+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)
  1. Disconnect connector IND1 from the outer rear view mirror RH.



  1. Check that the outer rear view mirror indicator turns on.



      B281830E01
    1. Apply battery voltage to the outer rear view mirror RH (outer rear view mirror indicator RH) and check that the outer rear view mirror indicator turns on.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → Terminal 1 (+)
      Battery negative (-) → Terminal 2 (-)
      Indicator turns on

      Text in Illustration 
      *a
      Component without harness connected
      (Outer Rear View Mirror RH)



NG
REPLACE OUTER REAR VIEW MIRROR RH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)
  1. Disconnect connector IND1 from the outer rear view mirror RH.

  1. Reconnect connector J13 to the outer rear view mirror assembly RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O28-6 (OMIR) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH (Click here)
OK

REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)