Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB3    Short to GND in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a ground short in the outer rear view mirror indicator LH.

DTC No.
DTC Detection Condition
Trouble Area
C1AB3
Both of the following conditions are met:
  1. Blind spot monitor main switch (warning canceling switch assembly) is on.
  1. The current that is sent from the blind spot monitor sensor to the indicator is above a specified level for a specified period of time.
  1. Outer rear view mirror LH
  2. Outer rear view mirror assembly LH
  3. Wire harness or connector
  4. Blind spot monitor sensor LH

WIRING DIAGRAM


E221720E02


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR LH - OUTER REAR VIEW MIRROR ASSEMBLY LH)
  1. Disconnect connector T10 from the blind spot monitor sensor LH.

  1. Disconnect connector K12 from the outer rear view mirror assembly LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K12-6 (BSL+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK OUTER REAR VIEW MIRROR LH (OUTER REAR VIEW MIRROR INDICATOR LH)
  1. Disconnect connector IND2 from the outer rear view mirror LH.



  1. Check that the outer rear view mirror indicator turns on.



      B281827E01
    1. Apply battery voltage to the outer rear view mirror LH (outer rear view mirror indicator LH) and check that the outer rear view mirror indicator turns on.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → Terminal 1 (+)
      Battery negative (-) → Terminal 2 (-)
      Indicator turns on

      Text in Illustration 
      *a
      Component without harness connected
      (Outer Rear View Mirror LH)



NG
REPLACE OUTER REAR VIEW MIRROR LH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR LH)
  1. Disconnect connector IND2 from the outer rear view mirror LH.

  1. Reconnect connector K12 to the outer rear view mirror assembly LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T10-6 (OMIL) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)