Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB5    Open in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an open in the outer rear view mirror indicator LH.

DTC No.
DTC Detection Condition
Trouble Area
C1AB5
Both of the following conditions are met:
  1. Blind spot monitor main switch (warning canceling switch assembly) is on.
  1. The current flowing to the indicator is below a specified value when indicator operation voltage is being sent to the indicator.
  1. Outer rear view mirror LH
  2. Outer rear view mirror assembly LH
  3. Wire harness or connector
  4. Blind spot monitor sensor LH

WIRING DIAGRAM


E221720E02


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR ASSEMBLY LH)
  1. Disconnect connector T10 from the blind spot monitor sensor LH.

  1. Disconnect connector K12 from the outer rear view mirror assembly LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T10-6 (OMIL) - K12-6 (BSL+)
    Always
    Below 1 Ω
    K12-5 (HL-) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT OUTER REAR VIEW MIRROR LH (OUTER REAR VIEW MIRROR INDICATOR LH)
  1. Disconnect connector K12 from the outer rear view mirror assembly LH.



  1. Check that the outer rear view mirror indicator turns on.



      E224415E01
    1. Apply battery voltage to the outer rear view mirror LH (outer rear view mirror indicator LH) and check that the outer rear view mirror indicator turns on.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → K12-6 (BSL+)
      Battery negative (-) → K12-5 (HL-)
      Indicator turns on

      Text in Illustration 
      *1
      Outer Rear View Mirror Indicator LH
      *a
      Component without harness connected
      (Outer Rear View Mirror Assembly LH)



NG
Go to step 4
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)  

4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR LH - OUTER REAR VIEW MIRROR ASSEMBLY LH)
  1. Disconnect connector IND2 from the outer rear view mirror LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K12-6 (BSL+) - IND2-1 (+)
    Always
    Below 1 Ω
    K12-5 (HL-) - IND1-2 (-)
    Always
    Below 1 Ω



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE OUTER REAR VIEW MIRROR LH (OUTER REAR VIEW MIRROR INDICATOR LH) (Click here)