Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1ABB    Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No.
DTC Detection Condition
Trouble Area
C1ABB
A beam axis inspection has not been performed.
Blind spot monitor sensor RH

INSPECTION PROCEDURE

1.PERFORM BEAM AXIS INSPECTION
  1. Perform beam axis inspection using the Techstream (Click here).


NEXT

END