DTC C1A47 Steering Angle Sensor |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A47 | A fail flag is transmitted from the steering sensor |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.REPLACE STEERING SENSOR |
Replace the steering sensor (Click here).
| NEXT | |
| 3.RECHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH (Master) | B |
| DTC is output from the blind spot monitor sensor LH (Slave) | C |
|
| ||||
|
| ||||
| A | ||
| ||